After initial warm up the ready light goes off then back on every couple of seconds. Is this the expected behavior or should it remain off completely? The same happens during the brew cycle.
While I don't have an Expobar, this is typical of other machines and indicates the heating circuit turning off and on to maintain the correct heat on the boiler. When you are preparing to steam, does the light stay on longer? If so, this is normal, due to the extra heat required by the boiler to produce steam 11-01-13 05:23PM
Please check the boiler pressure. the heater should be turn off once the pressure reach 1.0bar the light goes off, and light on again when the pressure drop down to 0.8bar. 11-01-13 05:23PM
Answer This Question
Please Sign In
to answer this question